Let’s be clear. There IS a difference between projection and return.
Ever get confused when the workroom or installer asks you what the hardware return is? Or what projection do you want on that valance?
Projection and return are two different things. The best way to explain it is this way. Projection is going from the wall out. Return is going back to the wall.
Drapery hardware projection and return are shown in the diagram above. As you can see, the projection is the whole bracket measurement from the back of the bracket to the front. The return is measured from the middle of the rod back to the wall.
Fabric returns back to the wall. For drapery panels the return is the fabric on the panel side that folds back to the wall and blocks the light on the sides.
Boards and hardware project out from the wall. For board mounted window treatments, the projection is depth of the board. The return is the fabric that is on the sides of the board mounted window treatments.
Shutters and binds project out from the window.
Knowing the difference comes in to play when ordering hardware or specifying a valance that has to clear shutters or blinds.Here’s an example of what can happen if you don’t understand these terms.
A designer specified drapery hardware for a window with existing shutters. At the measuring appointment the workroom was told by the designer what the bracket return should be. Panels were fabricated with the return measurement that was given. But when ordering the drapery hardware, the designer thought that the bracket projection and return measurements were interchangeable. At the install, she was shocked to see that the bracket return was much too small for the panels to hang clear of the shutters. The panels would not clear the shutters and thus laid over the top of them.
For more information on drapery hardware please go to the Seamless Workroom blog and download the PDF titled Soft Furnishings Designer Basics Drapery Hardware Explained. See link below.